Classic pinball machine power switch safety cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A protector for classic pinball machine power switch, that may have exposed live terminals even when switched off.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 56
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Share Alike
VERY IMPORTANT: POWER OFF AND UNPLUG THE GAME BEFORE INSTALLATION
Classic pinball machines were made at a time with more relaxed electrical safety requirements. There are many models out there with completely exposed or at least badly shrink tubed terminals in the mains power switch. Many people keep the game manual or other paperwork in there and since half of the power switch terminals are powered even when the machine is off, there's a risk of getting electrocuted.
This set of models is intended to be fitted in 60s, 70s and early 80s Williams, Bally and Gottlieb machines. The difference between the brands in the models are the screw holes and height of the cover. I encountered two different switch heights for Williams, so the short and tall models for the cover exist. The Bally model works at least for early Solid State models.
Print this out of wear and heat resistant materials, such as ABS or ASA. PETG might do the trick in a pinch. Adjust slicer settings so it'll print the 2mm thick walls as solid. Layer heights don't mean much.
When installing, absolutely make sure you have unplugged the game from the wall socket. Unscrew the 4 screws that hold the power switch plate onto the cabinet. In Williams models where the grounding strap goes under one of the four screws, make sure it goes below the cover! In Gottliebs the cutout for the wires goes towards the backbox. In Williams I came across multiple different ways the main power switch was wired, so you may have to point the cutout towards backbox, right side or coin door. Verify that the screws are tight enough so the power switch plate feels secure.