BTT TFT35 E3 [ender v-slot] side mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ender [3/v2/neo] side mount for the TFT35 display from BTT
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 134
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The idea here is to provide both a simple side mount using the Ender v-slot for the TFT35, and a back cover.
Since I couldn't find these requirements in a single simple concept, I remix these two models to fit my need.
Note : if you look carefully at the v-slot holes, you can achieve 3 different angles to position the TFT.
- This was printed in PETG, 0.2 and 45% infill... but 20 or 25% should be sufficient. I wouldn't recommand going below 15% because it will become loose in the long run.
- I used 4 insets (M3 4mm) in the front panel screw holes but it's not absolutely required (recommanded, but not required)