Core One tilting print sheet holder remix - parametric
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mainly the same model, but with openings for round magnets. Parametric FreeCAD model to set your magnet size!
- Ocena
- 5 / 5
- Polubienia
- 18
- Pobrania
- 97
- Wydruki
- 4
- Wyświetlenia
- 476
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A tilting print sheet holder for the left panel pocket of your Prusa CORE One. Based on the very practical design of Girak.
Holds 4 print sheets. The parts are meant to be held down by magnets. Magnets to hold the base in place and a magnet in each pivoting piece to hold it down (and the sheets up).
For the provided 3MF and STEP files, you need 11 round magnets in the size 8 x 5 mm. These magnets are holding the base strong on the case of the core one. The holes are the same diameter as the magnets. This makes them quite tight, and it takes some force to press the magnets in, but they stay in place without needing to be glued. The small holes are there so that the magnets can be pushed out again if necessary.
For the provided parametric FreeCAD files, I recommend not setting the size of the round magnets smaller than 6 x 3 mm or 5 x 4 mm or larger than 12 x 6 mm. You can set the size in the FreeCAD "Spreadsheet".
Recommended printing conditions: see 3MF files.
The remix was created with FreeCAD 1.02.