Dewalt 18v XR Drill Wall Mount (from Thingiverse)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix from https://www.thingiverse.com/thing:2900781
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 30
- Wydruki
- 2
- Wyświetlenia
- 431
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
This is a repost from https://www.thingiverse.com/thing:2900781
Here is the original summary from Thingiverse. Note that this is not my model, I'm reposting it since it's a great model and wanted to share it with the Prusa Printables community.
---------- Begin Here ------------
Summary
Well i've been hard at work redesigning my garage, and the number of times i put down my drill or impact driver and completely forgot where i put them was ridiculous so I set about searching for a holder etc. that i could wall mount.
There were a few out there but most seamed to but too restrictive for what i needed or just too big to fit onto my CTC Bizer printe, so I decided to make my own, with a simple design that fits both my DeWalt XR Drill/driver and my Dewalt Impat driver
Print Settings
Printer:
CTC Bizer
Rafts:
No
Supports:
No
Resolution:
Medium
Infill:
20%
Notes:
This design will use a lot of filament but has been disigned in a way that it will hold a drill and 5 amp battery without straining the print