Ender 3 V3 SE Cartographer and Beacon Mounts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ender 3 V3 SE with K1 Hotend mount for the cartographer V3m V4 and Beacon RevH with 0 y offset.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 380
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
There are three mounts, one each for cartographer v3, v4 and beacon revh.
I am slowly adding heat set insert variants too
This will not work with the original shroud or the original hotend, you might need to scale the mount horizontally f its not within the goldilocks zone.
So I originally started with a mount provided by user Esoterical that is not published, and it uses less of an y offset (-9mm vs -14.5mm) by offsetting the mount from the cr-touch mount. This was a real aha moment for me and I created my own version which has 0 y offset. The first version of this mount did use subshape binders from the original mount I was given, but this made the freecad project very complicated and difficult to change, ive since remodeled the mount from scratch to simplify things.
Please use the Pellcorp mount override in Simple AF!
x_offset: -18.0
y_offset: 0.0Make sure to print this upside down, use a brim to avoid it falling over, printing it laying down is likely to cause issues for the screw holes.
I added a V3 heat set inserts variant (the other variants will follow) for voron M3x5 heat set inserts, but untested.