Anderson power poles extension cord.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is the head piece for a 4-port power poles extension cord using 14 gauge power cord.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 297
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a four connector extension cord for power poles. This is the head piece for the four connector end, the single connector end uses my already existing single power poles shell further down my page. I'll link it at the end of this text.
This model is for 14 gauge power cord. Print all three pieces. Prepare four power poles connector pairs with short 20mm wire stubs coming off. Strip one end of the main power cord back 50mm to create the pos and negative buss wires. You can put the two halves of the shell together with the power poles wire end sticking up and this will hold them in line and spaced properly while you solder the connector wires to the buss wires.
Once they're all soldered, you can place them into one of the shell halves. The incoming wire hole has edges to fit in the split of the power cable, you may have to work them onto the wire and then slide the wire through to bring the connectors into the shell. Be very careful of stray strands of wire that could short across the buss.
You'll need two M4 x 14mm screws to put the halves together.
Here's a link to the single shell for the other end of the power cord.