Skådis tape holder for 4mm rods
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Used to hold multiple tape rolls on the IKEA skådis pegboard. Requires 4mm diameter rods of any length and material.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 53
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Print as many rod holders as you want. You can print one at a time, and build it one piece at a time, and just print more holders until it feels secure :)
Assembly:
When you assemble, rotate the rods to get them through the hole more easily.
Push the holders until they are at preferred lengths from eachother, rotate the rods back and forth to push them more smoothly.
You can rotate the rods again, and they should "lock" in place, since wooden rods are likely a tiny bit wider on some spots. Metal rods should also work though.
If you need to adjust, just rotate the rods again, until they move freely.
I went with one holder every 4 skådis holes, and the holder is very sturdy. I used 4mm wooden rods, about 510mm long. I used PETG and 20% infil. Prints without supports.
Hopefully this is useful for somebody :) I'm very glad if you remember to leave a like <3