1 / 4
Clamp Laptop Holder - Vertical Mount with printed Screw — zdjęcie 1
1 / 4

Clamp Laptop Holder - Vertical Mount with printed Screw

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A sturdy desk clamp that holds your laptop vertically at the table edge, freeing up valuable desk space.

Ocena
0 / 5
Polubienia
1
Pobrania
18
Wydruki
0
Wyświetlenia
137
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution

Specs:

- Very sturdy, keeps the laptop safe even from your cat (tested)
- Max laptop thickness: 24mm                                                                                                  
- Max desk thickness: 20mm                                                                                                    
- Clamping screw: M14 (printed, included in files)
- Uses 150-180g of filament depends on your infill settings
- Both dimensions are easily adjustable in the provided FreeCAD source files


Tested materials:

- PLA — recommended. Prints perfectly out of the box with honeycomb infill and 3-4 perimeters. No special settings needed.
- ASA — works, but requires tuning. The threaded hole tends to warp. If you go this route, use thick bridges, bridge flow 0.9, and be prepared for a few test prints. 


Print settings (PLA):

- 0.6mm nozzle (0.4mm works too, just slower)                                                                                 
- Honeycomb infill, 30%                                                                                                    
- 3-4 perimeters                                                                                                              
- No supports needed   


Feedback and makes welcome!

Tagi