1 / 4
Reusable zip-tie (cable tie) and french cleat mount — zdjęcie 1
1 / 4

Reusable zip-tie (cable tie) and french cleat mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

It's like a zip-tie.... but reusable!

Ocena
5 / 5
Polubienia
68
Pobrania
533
Wydruki
1
Wyświetlenia
1050
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This reusable zip-tie (cable tie) is designed as a durable, workshop-friendly alternative to single-use plastic ties. It uses a simple twist-lock mechanism that allows you to secure and release it repeatedly without cutting or damaging the strap.

The locking pin inserts through the looped end of the strap and turns 90 degrees to lock in place. Once rotated, it sits securely and resists pulling back through under normal tension. To release, simply rotate it back and slide it out — quick, clean, and reusable.

The strap is available in three different lengths to suit a variety of bundling needs, from small cable management jobs to larger workshop or garage tasks.

The minimum working diameter is approximately 20mm (0.8 inches). The PLA strap is designed to flex enough to allow a tight bend radius without snapping, while still maintaining good clamping strength once locked.

A small mounting base is also included. This allows the tie to be fixed to a flat surface using a screw or adhesive pad, making it ideal for semi-permanent cable routing or wall-mounted organisation setups.

This design is intended for general workshop, garage, hobby, and light-duty cable management use. I have also included a mount for french cleat system but easily adapted for other storage solutions. 

See design videos on YouTube – HERE

Subscribe and like the video if you would like to share your appreciation!

Print Settings

Reusable Zip-Tie

Material: PLA
Infill: 20% (increase for heavier load applications)
Supports: No (recommended orientation as provided)
Layer Height: 0.2mm standard
Perimeters: 3 recommended for durability

Tagi