uputronics Filtered LNA outdoor enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
keep your uputronics dry
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 67
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Engineering
- Licencja
- Creative Commons — Attribution — Noncommercial
these filtered LNA devices are more effective if they're on the antenna side of your feed line.. but the uputronics devices are not suited to be outside so I designed this simple enclosure.
Printed in ASA for maximum UV protection.
It seems a lot taller than necessary but that gives you room to have 6 inch coax cables between the lna and the bottom plate, with space to push the cable into the enclosure without bending them too much.
It worked best for me to use SMA elbows on the LNA, then having the cable cross over to the other side of the enclosure where the port is attached to the bottom plate (see photo).
The LNA rests on a couple of rails that stick out from the sides.
No supports required for printing. Uses m3 heat set inserts to attach the bottom plate.