Honda Del Sol Trunk Bumper Stop Kit (TPU)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A full Del Sol trunk rubber bumper replacement kit
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 43
- Wydruki
- 0
- Wyświetlenia
- 203
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a whole replacement kit for all the rubber bumper stops in the trunk lid, the square plastic trim clips and the two body plugs in the water channel of the trunk for the Honda Del Sol.
PRINT SETTINGS:
TPU ONLY, these replace rubber parts so it needs to be flexible
Print super slow for best quality, like 30mms outer walls, 40mms inner
2 walls strength is fine
Gyroid infill gives the best uniform squishiness, I used 20%
Supports are optional but it's best to use "tree (Auto) default" this makes support only on the insides of the threaded part of the two tall bumpers. (NOTE, you don't need to remove this kind of support after it prints either, it will screw in perfectly with the support inside the thread)
If you would like to leave a tip for my hard work you can do so here :D https://www.paypal.com/ncp/payment/Y5DRF7PN8S5AJ