Low profile photo clip for peg board
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holds a thick photo or cardstock on a typical USA pegboard.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 52
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Clips firmly on paper 1mm thick. (Cardstock or thin cardboard). If your photo is thinner, such as a typical photo you print at the store, you can slide extra paper behind the photo until it's thick enough.
Mounts on typical USA peg board with holes that are:
~ 25mm apart center to center
~ 4mm diameter
Printing Notes:
Print on end its long side with the photo slot facing the plate. The pegs will be pointing up into the air. (See the model images for reference)
Add supports under the pegs.
Dimensions:
Clip:
60mm wide (about 2.25")
8mm tall (without pegs)
2.7mm deep
Posts
3.5mm diameter, which gives some wiggle room in the 4mm holes in the peg board.