Philips OneBlade & Kingdom Come stand Anvil with charging function

Kingdom Come-inspired OneBlade Stand

General Information

The original charging cable is integrated into the hammer handle.

The cable simply needs to be threaded through the parts and pressed into the designated grooves, then the cable is invisible.

The accessories are integrated into the anvil. To improve the appearance, a lid was designed, with the tongs serving as the handle.

The water can drain away if the razor is used immediately after washing.

All parts are aligned for printing and only need to be imported into PrusaSlicer.

My print file with all parts is included in the data.

Only the anvil requires support, the rest can be printed without it.

Printed in PLA 0,2mm 15% infill

Assembly

1.     Place the “print_charge_holder” part on a table with the contour facing up

2.    Place the charging plug within the contour; the orientation is not important yet.

3.    Add the second part of “print_charge_holder” to it.

4.    Insert the assembly into the print_hammer_handle section. It's important that the connector is oriented correctly. Please rotate it as shown in the pictures during installation; otherwise, loading will not work. The hole in the component "print_hammer_handle" must be at the top and the deep groove of the connector at the bottom

5.    Thread the cable through the component print_hammer_silver and connect everything. Then screw it in place with an M3x10-M3x30 screw.

6.    Place the hammer on the anvil and use the "connector" component to glue the hammer to the anvil. Press the cable into the groove provided at the bottom.

7.    Take the lid and place it on the anvil. Insert the shaft for the lid. Ensure the correct rotation. 

8.    Glue the component "tongs" onto the lid using the 4 pins.

OneBlade Charging

Insert the OneBlade into the hammer handle and it will begin charging.

One Blade Accessories in Anvil

 Take the tongs and open the space for the accessories.

Happy Printing