Honeycomb Laser Bed Support with Cap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of https://www.thingiverse.com/thing:6663890. It's pretty much exactly the same except there is a lip…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 46
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
This is a remix of https://www.thingiverse.com/thing:6663890.
It's pretty much exactly the same except there is a lip to hold the laser bed in place.
The reason I made this remix is that while the original design is perfect if storing the laser bed on a horizontal surface, I like to hang my Artisan work beds (i.e. on a wall or the side of my Artisan's work table). The mating of the original support to the laser bed isn't tight enough to keep it fully secure when it's hung vertically. Adding a lip just holds the bed in place a bit more. This uses a 400x400mm "Two Trees" honeycomb bed. Here's one example on Amazon (https://a.co/d/i1i7ALs) but it's sold by several sellers if that link is out of stock, including on AliExpress.
I only printed one since I already have the 2 of the original design and I only needed one with a cap to secure it at the top, but it would be more secure by printing two and using both.
Category: Parts