Phillips One blade barrel holder with "secret" compartments

Design and details:

I designed this holder for the Philips Oneblade 360 Qp4631/65 with the goal of having a place for the body comb and skin protector, hidden when the blade is not in use, but at the same time being easily accessible  when needed. 

Parts list:

• 1x  - Barrel

• 2x - Holder

• 2x - Spring

  • Max outer diameter of 5,6 mm

  • Length between ~30-40 mm

  • Should have a fully compressed length of less than 15mm

  • If it is too powerful it can interfere with the opening.

    • I tried using the spring from a BIC pen, cut to length, but it was to stiff. 

  • I used one from a pen

Printing tips:

• Barrel:

  • I recommend printing this file with support. 

  • I recommend either a high infill percentage, fill the infill of the barrel with sand or other heavy stuff when printing as you want some wight behind in barrel so it doesn't lift up when you lift the shaver.

  • No support necessary on the bands and nails, so save yourself some time and filament here.

• Holders

  • There are 3 different versions of the holder, each holder grips the shaver with different tightness. 

    • When I tested the barrel with a printed version of the shaver i found that the one named holder 1.6 worked the best, but as i don't have the real shaver i don't know how well the fit is.

    • The one named holder 1.4 is a bit looser

    • The one named holder 1.8 is a bit tighter. 

    • try them out to see which one fits best.
      

  • These can be printed both with and with out support, depending on the orientation you prefer.

  • I recommend printing them standing up as this makes it so the layer lines follow the same direction as the barrel. This orientation however requires support
    

• It is also a possibility of printing them laying on the flat side, this orientation does not require support, however if you have problems with elephants foot on you printer, fitting the holder on the nubs on the barrel.

Assembly instructions:

Instructions are fairly simple, put in the springs in the holes before mounting the holders.

press the holders in to the openings in sides of the barrel, until the nobs on the barrel fall into place in the recesses in the holders.

Future improvements:

If this model sees any Interest I will look into improving some design elements. 
so far my list of improvements are as follows:

•  Make it fully printable.

  • Making a design with a 3d printable spring instead of the pen spring.

• More compatibility

  •  Designing holders and barrels for more Oneblade models.

  • Designing holders for other accessories.

• Space for more accessories 

  • Designing more space for fold out holders eg. front and back 

• Things not yet planned.

  • If you have any ideas write them in the comments and I will look in to it.