Donor spool holder for "PASTA lite"
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Requires 608 bearing! Donor spool holder for the "PASTA lite" system.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 76
- Wydruki
- 0
- Wyświetlenia
- 235
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
608 bearing required!
This is a donor spool holder for the PASTA lite Receiver:
The stock donor holders are only available on makerworld, which blocks downloads, so I made my own.
This holder attaches to the pasta lite receiver just like the stock holders. Place the single 608 bearing in the bottom piece and then place that piece on top of the arm. It should spin freely.
The friction of the bearing is very low. This can even become a problem because the donor spool keeps spinning when the receiver slows down, which can cause a mess. To remedy this, there are holes for three optional M3 cap-head screws (~6mm). With these screws in place, the outer metal ring of the bearing will slide on the heads of those screws, providing some metal-on-metal friction with low wear.
The FreeCAD model is parametric, which might be useful when resizing the holder for larger spools.