Trigger (Clamping Lever) for quick-release bar clamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replaced Clamping Lever for Quick-Release Bar Clamp.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 121
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a heavy-duty replacement trigger (clamping lever) for one-handed quick-grip bar clamps. It was specifically designed to replace the fragile stock plastic triggers found on brands like Somar and Schulz, which often snap under high pressure.
The geometry has been reinforced around the pivot point to ensure a longer lifespan and smoother operation of the driving plates.
Print Settings
Printer: Printed on an Ender 3 Neo.
Layer Height: 0.2 mm.
Material: Black ABS
Infill: 40% Grid.
Wall Line Count: 6
Supports: Required.
Orientation: Print it on its side for maximum structural integrity.
Special Note:
The model features intentional grooves designed to force the slicer to create additional solid walls. This design choice increases mechanical resistance by placing solid material exactly where it's needed, making the part much stronger than if it were relying solely on infill. Make sure your "Slicing Mode" or equivalent setting in your slicer processes these internal features correctly.