Sovol Zero - Recirculation Filter (uses existing Exhaust Fan)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I primarily print ABS/ASA and wanted a to repurpose the exhaust fan to be recirculate the air with a filter & charcoal
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 197
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to do as little modification as possible to the printer just to make life easier.
This remix removes the exhaust functionality of the printer and repurposed the exhaust fan to recirculate the chamber air and filter with activated charcoal and Hepa filter.
*Same as the original model use a height modifier to 0 - 02.65 with 25% Honeycomb on the top portion
BOM
M3x6 x4 to mount filter housing to holes that were previously used
M3x35 x2 to secure Fan
M3x4x5 heatset inserts, shorter length heatsets can be used.
Acid Free Activated Charcoal
Hepa Filter: https://www.amazon.com/dp/B0782T7L6P?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_8
I also updated this in the Printer.cfg so that the recirculating fan turns on only when the bed is at 100 degrees or higher, so you don't have to remember to turn it on.
*If updating this section in the config file, In the "Cooling" section of the "Filament" settings make sure that "Active Air Filtration" is unselected.
[heater_fan Recirc] # exhaust fan
pin: PB0
max_power: 1
cycle_time: 0.015
kick_start_time: 0.5
heater: heater_bed
heater_temp: 100.0