1 / 5
DIY Laser Darts Oche (4€) for GroMech3D Autodarts Setup — zdjęcie 1
1 / 5

DIY Laser Darts Oche (4€) for GroMech3D Autodarts Setup

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A budget-friendly DIY Laser Oche remix for Autodarts, designed for a cheap €4 AliExpress line laser.

Ocena
0 / 5
Polubienia
9
Pobrania
52
Wydruki
0
Wyświetlenia
564
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Sports
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a DIY laser oche for the Autodarts setup by GroMech3D, using a €4 line laser module. It’s not as bright as the Winmau Oche, but it’s definitely enough for a home setup.

Assembly & Adjustment:

The initial calibration requires a steady hand and some patience. You need to align the line straight and focus the laser (adjust the lens) to get a sharp projection. Once it’s dialed in, it stays perfectly in place.

Calibration process: 

1. Insert & Align: Push the laser module into the holder while ensuring the line is perfectly horizontal

2. Focus: Rotate the rear part of the laser module to sharpen the beam until the line is crisp.

3. Lock: Once everything is dialed in, secure the module with the M2 screw to prevent it from rotating

4. Distance: Use the M3x16 screw at the joint to adjust the final distance to the board and lock the angle

 

Hardware needed: 

1x M3x16 screw for the joint

1x short M2 screw to secure the laser module and prevent it from rotating

Aliexpress: https://de.aliexpress.com/item/1005007697039551.html (Make sure to select the line laser!)

Tagi