Dynamic Phone Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- GNU General Public License v3.0
USE 20% INFILL and TRI-HEXAGON PATTERN. Print the BUILD PLATE.
Insert Left and Right pieces into the holder. You can tell which is which based on the teeth side relative to the guide rails. LEFT PIECE ON TOP. Right piece under it. Push them in all the way so they are touching each other. Center them. Push down piece into holder as well. Make sure the side that slides out is the side the closer to the teeth on teh LEFT piece. Next, put gear onto pin on the holder. Make sure 2 teeth are disengaged on left and right pieces. On the down piece, 1 teeth should be engaged. engaged means it is stuck between 2 of teh gear's teeth. (Look at onshape model if confusing). Finally, slide entire assembled holder onto the stand piece.