Klipper IP Address CYD Scanner
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Uses a CYD touch screen to scan your network for all powered on and connected Klipper based 3D printers.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 108
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This little tool will scan the devices on your local network and look for any Klipper based 3D printer. It works with printers running Mainsail or Fluidd whether they are on WiFi or LAN.
Features:
-Shows the IP of the Klipper Scanner itself
-Shows the IP of each printer with the name it was assigned in its respective settings (i.e Fluidd or Mainsail)
I take no credit for this except for putting it all together. The idea came from @Rolohaun3D after watching this video of a device he created.
Minus a few alterations, the case is from @TeachingTech
The Arduino code was created over several hours using various LLM's.
Hardware Required:
2.8" 240*320 ILI9341 Smart Display Screen 2.8inch SPI LCD commonly referred to as a CYD yellow screen.
4 x M3x12mm I used countersunk ones for a flat back
Installation:
Load up Arduino IDE. Open the provided sketch and replace YOUR_WIFI_NAME with the name of your 2.4GHZ WiFi and YOUR_WIFI_PASSWORD with the password. Keep the " ".
Upload Settings:
CPU Frequency - 240mhz
Flash Frequency - 80mhz
Flash Size - 4mb
Flash Speed - 921600