Magnet Adapters for Core One / + Scadis Mode
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Various magnet adapters, including for after printing.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 287
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
IMPORTANT!!!
Hinge shafts MUST be printed on the side, such that layer lines will end up crossing from the external part of the hinge to the internal part of the hinge, or in other words - each layer must have one side that is close to the part that touches the printer, and another side that is close to the swiveling part. Otherwise the pressure on the shaft may end up splitting the layers apart.
Update:
Added top upper rail alternatives with places for 9 10x3 magnets each - because I have many magnets but they are very weak, and the whole thing is becoming too heavy for just one.
Update: added matching hinges with 10 10x3 magnets each.
Attachment type parts have gridded side on them. They are meand for use with epoxy glue - scratch the surface of the part you want to attach them to, apply epoxy to the gridded area and to the scrached area and put them together.
After Print 10x3 Magnet Attachment: make sure the magnet holes on both parts face the same way when putting them together.
Spacer type parts are meant to be glued inside a magnet hole underneath the actual magnet. Good if your magnets are thinner than the required ones to flush them with the surface. Make sure the spacer is applyed first, so that the magnet is flush with the part's surface and is as close as possible to the metalic part to be magnetted to.