Dog Bowl Water Bottle Refill
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Split into 2 pieces as the original broke along layer lines where it hooks under the lip of the bowl.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 157
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial
Printing the section that hooks on the dog bowl on its side reduces supports needed and printing across the stress point of connection with the bowl stops it from breaking along layer lines under the weight of a full 1.5L bottle. Dovetail joint also makes refilling the bottle easier as you just slide the bottle section on and off, no fiddling about getting splashed while trying to get it to hook back on.
There's no tolerance on the joint because I apparently forgot that was something important, so the male end is slightly too large for the female end. I softened it with heat then smushed it into the female end and then cleaned it up with a craft knife, but feel free to use your preferred method of removing excess material.