1 / 1
Replacement foot with screw holes for Smart Air Sqair/Smart Health S Air Purifier — zdjęcie 1

Replacement foot with screw holes for Smart Air Sqair/Smart Health S Air Purifier

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement foot

Ocena
0 / 5
Polubienia
1
Pobrania
5
Wydruki
0
Wyświetlenia
27
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Attaches to the base of the air purifier with what I want to say is an M6 nut. Could be an M5; unfortunately it's been a while and I don't remember. Install the nut loosely on all feet, then put the air purifier on a flat surface and tighten. You will probably need a right angle driver/wrench.

My use case was to use this to secure the air purifier to a surface, so it fits #8 wood screws. Only one screw per foot is really needed. It can also be used to replace individual feet or used freestanding. 

Print on the leg's side. Supports may be helpful in the center section and on the nut end, but also may not be necessary.

The angle of the leg is probably still <1 degree off, but it works fine enough. 

Tagi