1 / 8
Worthikids Bigtop Burger Food Truck — zdjęcie 1
1 / 8

Worthikids Bigtop Burger Food Truck

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The Bigtop Burger Food Truck from the animated series Bigtop Burger by Worthikids on YouTube.

Ocena
0 / 5
Polubienia
5
Pobrania
34
Wydruki
0
Wyświetlenia
159
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Vehicles
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is the food truck from Bigtop Burger. The truck itself and Bigtop burger belongs to Worthikids on YouTube, all I did was create this model and paint it.

Included Files:

There is an STL and Step file of the model, they are same just use whichever you prefer.

There is also a PDF file of the menu for you to cut out and tape into the frame on the model

Finally, there is a .f3d file, which is the Fusion360 model you can use for slightly easier modifying of the model.

Print instructions:

I personally printed this wheels down with support enabled. It could also be printed upside down with decent results, but either way supports are required and you’ll need to be careful removing them, especially around the mirrors as those are still more fragile than I’d like.

I’d recommend using alternative wall generation like Arachne if your printer supports it to ensure some of the smaller details come out a little better, but it should work without it too.

I used a layer height of 0.12mm but for this model the smaller the layer height you can do is probably better as long as your support settings are alright. I also used a 10% infill since most of this is a cube doing too much more infill is a waste of material. 

Assembly and Finishing Touches:

This model is a single part so there’s not really that much assembly. However, I’d recommend painting your print if you have the time. As a final step after painting, I would recommend printing out the menu pdf I included, cutting out the menu itself and then taping or gluing the paper into the small frame on the model. You might need to trim the edges of it. You can also write or paint it yourself if you’re that talented, I certainly am not.

Tagi