Stand for Portable Monitors and Tablets
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial
Should be able to handle bigger and heavier monitors too. Instead of printing the rod yourself, you can also use a 15mm wooden rod. However, you won't be able to fit it into the foot's clip since the printed version has a flattened side.
I used PLA for this; I would recommend adding fuzzy skin on the inside of the foot's rod mounting holes like this →
In total, this print uses just under 100g of filament and takes under two hours on my Elegoo Centauri Carbon 2.
I used 0.28mm layer height and 30% triangular infill as well as variable layer height for the rod.
Uses this bolt made by @Rick_2197495:
For mounting the monitor to the VESA holes, I printed these M4 screws, though normal ones will work fine as well obviously: