Neptune 4 / 4 Pro Spool Holder with 608 Bearing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Neptune 4 / 4 Pro Spool Holder with 608 Bearing
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 47
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Many of the spool holder models with ball bearings I found had an issue with the thread alignment. You often have to choose between tightening the parts properly or aligning them correctly. Because of that, I designed this model so the alignment of the threads no longer matters while still allowing the spool to rotate smoothly on ball bearings.
You will need two of each part, except for the Roll_Cap, which is required four times.
In addition to the printed parts, you will need:
Aluminum rod – 8 mm diameter, 24 cm length
4× Bearing Type 608 – 8mm x 22mm x 7mm
2× M3×10 screws to attach the end caps
A hole is included to secure the rod to the connector with a screw, but in my case the rod fit tightly enough that I didn’t need to use one.
---
Viele der Spulenhalter-Modelle mit Kugellagern, die ich gefunden habe, hatten ein Problem mit der Ausrichtung der Gewinde. Man musste sich oft zwischen „richtig festziehen“ und „korrekt ausrichten“ entscheiden. Deshalb habe ich dieses Modell so entworfen, dass die Ausrichtung der Gewinde keine Rolle mehr spielt und sich die Spule trotzdem leichtgängig auf Kugellagern drehen kann.
Du benötigst von jedem Teil zwei Stück, außer von der Roll_Cap, davon werden vier Stück benötigt.
Zusätzlich zu den gedruckten Teilen brauchst du:
Aluminiumstange – 8 mm Durchmesser, 24 cm Länge
4× Kugellager Typ 608 – 8mm x 22mm x 7mm
2× M3×10 Schrauben zur Befestigung der Endkappen
Es ist eine Bohrung vorgesehen, um die Stange mit einer Schraube am Connector zu fixieren. In meinem Fall saß die Stange jedoch so fest, dass ich dort keine Schraube benötigt habe.
