Piston & DI Drop-in Handgaurd + accesories
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A drop in handguard for DI and Piston uppers with a bundle of accessories for customization
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 101
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
>Round and Oval handguards for internal piston and external piston uppers.
>These are 2 piece drop-in for round carbine length end-caps and are sized for 10.5" barrels.
>Accessory pack includes m-lok cutouts, 1913 rail segment, a handstop, an angled foregrip, a sling loop, a and sling bar.
>Takes 12 M4 set screws that are about 14-20 mm long
-------------------------------
If you want to customize a handguard, all the stuff you need is in the "customizing stuff" folder. I have a generic example of a customized handguard in there as well.
These are meant to be printed at 100% infill in nylon. For best results, soak in water for a day or two to hydrate the nylon before install. Put the handguard on like any other 2 piece drop-in handguard and then screw the two handguard halves together. And after you do that, install four screws into the angled holes at the bottom of the handguard. The angled screws will push against the barrel nut to lock the handguard into place.
Optionally before install you can coat the inside of the handguards in high temperature gasket sealant to protect them from the heat, or just cut a sheet out of a soda can and glue that to the inside.
The piston handguard is sized for the Adams Arms piston kit, and although the DI handguard will fit the adams arms piston, it will have almost no clearance between the handguard and the gas block.