John's Overhang-xiety Eliminator
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A standardized support calibration model for every slicer, every printer, and every maker who's tired of guessing.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 68
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Supports. The necessary evil of 3D printing — and the setting nobody properly tests until something goes catastrophically wrong on a print they actually cared about.
Spoiler: this model won't eliminate the anxiety. But it'll replace the guesswork with actual data.
The Overhang-xiety Eliminator gives you a consistent, repeatable geometry to test your support settings against — multiple overhang angles, bridge spans, and support-dependent surfaces in one quick print. Works with PrusaSlicer, Cura, Orca, Bambu Studio, or whatever you're running.
Tweak one setting. Print it again. Know exactly what changed and why.
✅ Multiple overhang angles and bridge spans in one model
✅ Slicer agnostic — test on any printer, any software
✅ Fast enough to run multiple iterations without losing the plot
✅ Repeatable geometry so you're always comparing apples to apples
Found settings that work beautifully? Post your Make and drop them in the comments.
This is exactly the kind of thing that makes Printables actually useful — your dialed settings could save someone else hours of frustration.
(Yes the upside-down loophole exists. No, it doesn't count. You know this.)