USB clip for Charging stand for vacuum Fanttik Slim V8 Apex
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Clip for holding a USB-C cable in place for use with @DanielJ_2100544's Charging stand for vacuum Fanttik Slim V8 Apex
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 72
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
I made @DanielJ_2100544's Charging stand for vacuum Fanttik Slim V8 Apex but wanted to have the charger connect when the vacuum is put in the holder rather than having to manually plug it it.
The placement of the cable in the original model allowed for a simple clip to hold the USB-C connector in the proper orientation so that it plugs in when you place the vacuum in the holder. You have to make sure that the logo is aligned with the front but that is pretty easy to get it to plug in reliably.
This fits the USB-C charging cord that came with my Fanttik V8 Vacuum, but I can't vouch for it fitting every connector of course. It all fits snuggly in my holder. Assembling just requires sandwiching the connector between the two halves and using needle nose pliers to push the assembly into the base of the holder. The two halves are not identical. One side does not have a full lip so that it fits up against the wall of the holder.
On my prints, both the cable into the clip and the clip into the holder were very snug. Which is good as it needs no glue but it does require some force to assemble.