Vevor Cyclone Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The Vevor Dust Cyclone (SKL300) claims to have 4" (100 mm) Interface but the tech spec describes as 3.81" (97 mm) which makes the hose connection rather loose.
As the original outlet is quite short and gives not much area to fit a clamp around, i've created an Adapter to extend the Outlet by around 1/2" and make it real 4" (100 mm) in outer Diameter.
It has a little notch cut out to reach a bit deeper around the ramp for better fit.
Printing recommendations
print with 0.4 nozzle and 5 walls.
use outer Brim
printed mine with ABS but the other cyclone adapters in my workshop are all printed in PLA and held up fine over the years.
Added an 4" (100 mm) Inlet Adapter.
Added an Adapter for 2 1/2" (63 mm) Hose Connection. It has an 2 1/2" (63 mm) outer Diamater and 58 mm inner Diameter. Can be used on the Inlet or Outlet of the Cyclone.