Double flow sensor stand (for Lindr cooler and Robopípa)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Double OF07ZAT flow sensor stand with 33mm distance
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 59
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Table stand for 1 or 2 flowmon sensors with hose distance of 33mm. Ideal for use with "Robopípa".
BOM:
- 1x Stojanek
- 2x Distance_velka (or hexa spacer columns from PCs)
- 4x heat-insert M3 OD5 L4 (no need if you use hexa spacer columns from PCs)
- 2x Distance_mala
- 4x screw M3x20 (with or without washer)
Assembly:
- put 2x heat insert to each "Distance_velka"
- slide-in sensors, add firmly screws to the right holders (1 from front, 1 from back)
- attach Distance_velka in between back sensor and front "wall"
- tighten both right screws
- do the same with left side, but attach also Distance_mala between stand wall and sensor mount
Left side uses removable distances so you can easily slide out the flow meter without bending tubes attached to cooler (just slide it away to the left with tube left in cooler).
Print:
- print oriented as in STL files, no supports, 15% infill, 3 perimeters
EDIT 13.03.2026 - raised sensors so they should match height of Lindr cooler beer pipe (33mm over ground)