1 / 3
DW660 blower redirection
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
Little chute to redirect output air from DW660 to blow onto the cutting area.
Two little pegs are intended to fit within the output ports to hold it in place. Two holes near the top of the part are intended for #6 sheet metal screws to act as standoffs against the router body to adjust the orientation of the chute.
I used a zip tie to hold the chute in place against the router.
There is no "good" surface to put on the bed but I managed to print successfully with one of the facets near the bottom of the model laying flat on the bed.
Category: Parts