1 / 7
LED-Brick-Holder for 75192 UCS Millennium Falcon — zdjęcie 1
1 / 7

LED-Brick-Holder for 75192 UCS Millennium Falcon

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Holder for up to 20 pieces of 1x4 LED-Bricks for the USC Millennium Falcon

Ocena
0 / 5
Polubienia
3
Pobrania
11
Wydruki
0
Wyświetlenia
226
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

I have created a holder for 1x4 LED bricks that fits into the 75192 USC Millennium Falcon. The holder is specifically designed for the Millennium Falcon MOC-37267 “Millennium Falcon UCS Engine MOD v2,” but with minor modifications, it may also fit into the standard Falcon (not tested).

With the holders, you can attach 10 of the 1x4 LED bricks on each side, giving you a total of 60 LEDs to illuminate the engine.

Printed parts:

Layer height: 0.15

Perimeter: 3

Infill: 10%

Support: No

Material: PLA (I used PLA matte because it has more grip).

Required parts:

4x Technic Axle Pin (43093)

2x Technic Pin (2780)

2x Plate 2 x 3 (3021) - optional but recommended

20x 1x4 LED bricks with USB connector and PCB strips (Aliexpress)

1x connection cable set (Aliexpress)

Assembly:

The holders are attached to the Technic Beam 2 x 4 L-shape on the right and left with the Technic pins and in the middle with the Technic axle pins (see pictures).

After assembly, the holder can be bent slightly at the ends in the middle to illuminate the center a little better.

Optionally, the 2 x 4 plates in the middle can be replaced with the 2 x 3 plates at the hinge so that the lower attachments are not pushed down.

The design is not quite perfect yet, so I may optimize it in the future.

Tagi