Squeeze Clamp Pads Jorgensen and Irwin
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Jorgensen E-Z Hold 12 inch Clamp Pad-should work for the 6" clamps, also. Irwin Clamp Pad
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 106
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed some replacement clamp pads. So, I made them.
Here are some recommendations:
I used Overture High Speed TPU 95A. I guess any 95A TPU would work. It seems pretty close to the stiffness and grip of the original clamp pads. If you find a better material, let me know!
I used a 0.6mm nozzle, so a 0.4mm nozzle should work fine.
It's probably best to use 100% infill or increase the wall count to fill all the voids to make it as stiff as possible.
If you have a textured plate, it's probably better to use that to increase the grip of the pad.
--2026-03-13 Added Irwin clamp pad model. This one requires support.