Uni Kuru Toga Pencil Case

Everything you need for good design is a pencil and a piece of paper. So whenever I have an idea I do a lot of sketching. For this I love my Kuru Toga pencil and I keep it right next to my sketchbook, wherever I go. But it's tip is very sensitive and I wanted to keep it safe inside my backpack. My last sketchbook had a spiral binding and the pencil fit right into it so it was safe in there. But my new sketchbook's spiral binding has a smaller diameter so I needed some kind of case for my pencil. I wanted it to be as simple and small as possible, but still effective and practical. So I designed this case. It uses the pen's pusher to lock it in place.

I also made a version with a little hook so that the pencil can be attached to the spiral.

Print Settings

Printer Brand:

Creality

Printer: 

Ender 3 Pro

Rafts:

No

Supports: 

Yes

Resolution:

0,2mm

Infill: 

20%

Filament: DasFilament PETG Bright orange (Leuchtorange)

Notes:

I printed it only using supports touching the built plate. So the only supports generatet were at the end of the part under the arc. The hole for the pencils tip prints quite well without supports.
On the version with the hook there is a little support for the overhang. You can cut it away after printing.

Filament: DasFilament