1 / 3
Apple Watch Ultra & Airpods Pro 3 Charging Dock Combo v3 — zdjęcie 1
1 / 3

Apple Watch Ultra & Airpods Pro 3 Charging Dock Combo v3

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I updated my favorite charging dock model to support my new Airpods Pro 3 & Apple Watch Ultra 2.

Ocena
0 / 5
Polubienia
5
Pobrania
70
Wydruki
0
Wyświetlenia
331
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution — Share Alike

This is the final V3 iteration of the dock to allow for use with the latest Airpods Pro 3, and Apple Watch Ultra (all Apple Watch models should be supported). I used the standard Apple charging cable that came with my MacBook Air M1 for my reference for fitment. I also hated the bottom plate from the original design so i just made a solid piece with hole & channel cutouts large enough to pass through the Apple charger's USB-C end.

Print Settings:

  • I printed in PETG used snug supports and wanted the top visible surfaces ironed, and I printed it at 0.20 mm layer height and specified the topmost curved part to be 0.15mm layer height (see .3mf file)

Final V3 (this version fits the Apple USB-C to USB-C charging cable that came with my MacBook Air M1): 

  • I made the USB-C cable socket for the Airpods Pro 3 charging fit the Apple USB-C cable that came withy my MacBook Air M1

    • The approximate dimensions of the USB-C end are 17mm height x 10.2mm width x 6.25mm thickness. The protective sheathing right below the end is 10mm tall, diameter of 4.85mm. The braided cable has a diameter of 3.5mm.

  • Raised the placement of the Airpods Pro 3 to allow for less bending of the charging cable and opened up the channel to allow the thicker gauge cord to nest nicely.

  • To secure the Apple Watch fast charger in place (it moves a bit for the snap-in fitment), I placed a piece of 3M Double Sided VBH foam acrylic tape (I used 4930 - 25 Mils thick) on the back side. It pushes it out enough that the watch makes good contact with the charger and my Apple Watch Ultra 2 sits nicely in the now expanded indent for the watch to rest on. 

  • I used the same adhesive tape to secure it to my nightstand - I recommend putting double sided tape over the cable channels on the underside to keep it sitting nice and flush. I had my Airpods Pro 3 seated into the dock and verified charging before I locked down the cables in those channels (there is a slight amount of play in the USB-C socket).

V2 (this version fits the Apple USB-C end of the standard Apple Lightning charging cable): 

  • I initially intended to use the Apple USB-C to USB-C cable that came with my Iphone Air, but I later found out that the connector end and cord dimensions do vary quite a bit between different iterations of the Apple USB-C cables... frustrating.

  • I cleaned up rear lower 

  • I made cable routing less jagged

  • I opened hole for watch charger connector to allow for Apple fast charger

Tagi