1 / 5
Ridgid 18V Battery Charger Slatwall Bracket R86093 — zdjęcie 1
1 / 5

Ridgid 18V Battery Charger Slatwall Bracket R86093

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This bracket allows you to hang your Ridgid 18V Lithium-ion battery charger off of standard "slatwall" sold at Menards

Ocena
0 / 5
Polubienia
2
Pobrania
20
Wydruki
0
Wyświetlenia
116
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Public Domain

This is a no-fasteners bracket that snaps around your RIDGID 18V battery charger to allow it to be hung directly on slatwall.  You simply press it down over the two mushroom shaped studs bending the finger out of the way and then slide it back until the finger pops up and locks the charger in place.  I print mine in PETG so the flexible finger is flexible enough to do its job. 

Recommendations:

PETG material

Print on its edge with the finger pointing up.

Print with TREE SUPPORTS to make the two studs printable.

0.2mm layer height works fine.

4 walls and 25% infill recommended.

Tagi