1 / 5
Qidi Q2 Box:  Cardboard Spool rings and Box Rear Roller — zdjęcie 1
1 / 5

Qidi Q2 Box: Cardboard Spool rings and Box Rear Roller

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Cardboard filament spool rings to fit Polymaker and Overture spools. Plus a ø15mm OD rear roller for the Box.

Ocena
5 / 5
Polubienia
41
Pobrania
255
Wydruki
1
Wyświetlenia
1199
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

The Qidi Box has very limited space to fit ø200mm spools.  During my limited first use, I had no problem running cardboard Polymaker and Overture spools.  But the cardboard does wear down over time and I thought "no problem, I will print ready-made spool rings".  However, I didn't find what I wanted so iterated many times with various dimensions in SolidWorks.  Rings that fit inside the box were too thin and broke.  Everything else would rub the lid. 

I ended up with rings of ø199.25mm I.D.  O.D. is less than 202mm.  I still had the right spool rubbing the Box lid with whatever filament spool I was test fitting.  So, I did what I didn't want to do.  I printed a slightly smaller rear roller - perahps minus 1mm (ø15mm).  The end pins are ø3mm to fit the bearings.  Printed pins of ASA break easily.  I bought 3mm carbon rod to fix that.  Printed pins may work if you push the roller/bearing assembly into the Box very carefully.  I drilled out the roller with a 3mm drill bit rather than mess with oversizing the hole.

The spool rings have pairs of holes to match Polymaker and Overture spools.  Two holes have pegs to engage the spool holes.  Not necessary on my spools as they fit very tight.  A lip on the ring makes them kind of snap into place.  They've been working for me but I haven't gone through many spools.

The Qidi Q2 is no Bambu, but I do like the heated chamber and high nozzle temps.