Funwheel X7 - Mudguards (front)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Non-invasive Mudguards/connector-protectors for the fungi controller box + x7 rails
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 68
- Wydruki
- 1
- Wyświetlenia
- 263
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Set of mudguards/connector-protectors for the Fungineers X7 board.
The guards require no alterations to any of the hardware on the board. to equip them, the front bumper needs to be removed. Then they will slot into place with relative ease. once there, they will stay in their place without additional screws. Mounting the bumper will secure them.
Recommended filaments to print them would be:
1. PETG
2. PBTpro
3.TPU
once equipped, the top will sit flush against the fender delete/ fender that is mounted. If you do not have either, be sure to print some.
https://www.printables.com/model/1546618-droptop-fender-funwheel-x7
https://www.printables.com/model/1562516-funwheel-x7-fender-delete