Steelcase Gesture Top Bracket Adapter for Atlas Headrest
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Steelcase Gesture Top Bracket Adapter for Atlas Headrest
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 222
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I slightly remixed this https://grabcad.com/library/atlas-adaptor-bracket-for-steelcase-gesture-1 top adapter to make it compatible with M2.5 heat inserts.
I uploaded the .STEP file so that anyone can change the diameter of the hole to use whatever size they prefer. Just make sure that the hole is concentric.
If you can't figure out how to find the hole from the original instructions, you need some compasses. Open it at 2.85mm, put the point in each of the 2 smaller holes, and trace the arch. Obviously, the intersection is where you need to drill.
Use some washers for the screws. I made one quickly to 3D print but it might snap. Not that you need to tighten it that much, the screw only prevent the bracket from rotating.