Qidi Polar Cooler Stand w/ Drainage Bin
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a stand for the Qidi Polar Cooler that has a bin for storage and one for drainage from the cooler.
- Ocena
- 5 / 5
- Polubienia
- 34
- Pobrania
- 376
- Wydruki
- 1
- Wyświetlenia
- 909
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This is basically a functional rough draft of a stand I made for the Polar Cooler. The smaller rear bin with the whole is for the drainage of the cooler, the larger bin on the front is for whatever you can cram into it.
It is well vented and should allow for a lot of drainage to evaporate. I used PLA+2.0 for this print, PETG would probably be a better option for the water resistance. I believe it is recommended to use 4 walls for PLA for water and 0.15 layer height or lower. Again PETG is probably better for this but PLA can work. Of course empty the bin as often as needed, this will vary person to person.
I'll eventually make an updated version of this.