Passive Fume Extractor for Soldering Iron Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A fume extractor designed to catch all the stray soldering fumes that come off your iron.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 46
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A special fume extractor designed to catch all the stray soldering fumes that come off your iron when you tin it and put it back on the stand.
This was designed primarily for use with a Metcal MX-500, but it works with other soldering irons, such as the Weller WESD51.
Printed at 0.2mm layer height with supports only necessary for the big overhangs on the side support with the controller holder.
Parts:
USB 5v 80mm Fan with controls (https://www.amazon.com/dp/B0951LW6Z3)
USB 2.0 extension cable (recommended)
Carbon filter sheet
5x M4x6mm Screws
5x M4 Nuts
2x M3x16 Screws
2x M3 Nuts
UPDATE (7/15): I've added some "width extenders" that simply add a bit of space between the right side of the fan holder and the right support. These are handy for getting the passive fume extractor to fit over wider soldering iron holders.
The width extenders are either 4mm and 8mm for screw size convenience, but you can stack them or cut them to a custom length in your slicer. Keep in mind that these offset the center of the fume extractor and will require slightly longer M4 screws (original 6mm +4 or +8). Also because of this (and since the longest M3 screws I had were 20mm) I've created a "Width Extender Lid" that simply has the indent for the right-side washer moved slightly closer to the side.