Snapmaker U1 Samla LED holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Clip on holders for LEDs for the Samla top cover on the U1
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 18
- Wydruki
- 1
- Wyświetlenia
- 540
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Holders to insert LED strips into for adding light to the top of your U1 printer. Sized for the LED strips I had on hand (links below).
I printed with .2 layer height, 4 walls - I used white PolyLite ASA but mainly because that is what I had loaded already on that printer. All 4 parts fit on the plate for both my Bambu P1S and the Snapmaker U1.
Cut 2x300 and 2x150 strips (these LEDs have 50mm spaced cut points), solder the strips, stick them in (tight fit by design), and insert into ribs on top of the samla bin. You may need to cut a little of the ribs around the 150mm lengths to allow the wires in and out.
I used the following parts:
PWM Adapter & Switch (optional): https://www.amazon.com/dp/B0B4SC7XV4