Replacement Guitar Neck/Bridge Pickup Rings
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Some simple replacement pickup rings with screw holes at 79.5mm x 35.5mm to fit my specific hardware on a Kramer Pacer.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 227
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Noncommercial
My 2016 Kramer Pacer has Seymour Duncan Invaders installed by a previous owner and the pickup rings didn't fit quite right due to the mounting screw holes not aligning correctly with the original pickup rings, causing them to bow on the bottom side. Be aware that the screw hole spacing may need to be modified to fit your specific guitar. Instead of filling and re-drilling the holes, it just seemed easier to print some new rings with the correct spacing for my guitar.
I'd suggest printing the first few layers for a test piece to check that the holes line up. I've included the fusion 360 file if you need to adjust the holes for the hardware, editing the "RingDimensions" sketch will update both the neck and bridge models.
I printed these with 100% infill, and ironing enabled on the top layer.
Printed on a BambuLabs P1S, with a supertack coolplate, and Overture PLA. Took about an hour total.
I also painted them with primer and clear coat to better match the original pickup rings.