Rotary Damper v1.0 for Mark Ayton's Speedbrake and Flaps mechanism for A320
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This part fits into Mark Ayton's Flaps and Speed Brake mechanism, also uploaded here.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 84
- Wydruki
- 0
- Wyświetlenia
- 371
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Public Domain
I could not find the Rotary Damper on the Market or only for high prices. So I created this part myself.
Additional material:
What you need is an O-ring with 8 mm and 1,5 mm thickness as well as silicone oil. I used a viscosity of 30000 which is the very lower level, if you wish you can use higher viscosities less is not recommended for the Speedbrake and Flaps lever. I made good experience with 500K viscosity. You get this oil on Amazon and other rc-model sites, it is used for rc-car shock absorbers. This part fits into Mark Ayton's Flaps and Speed Brake mechanism, also uploaded here.
Printing:
I used PLA material, you can use PETG for the cogwheel and the rotor if you wish, but PLA is fine.
Assembling:
After printing, install the O-ring, fill in 3,0 ml silicone oil with a 5 ml syringe (pull up to 4 ml) in the open housing, after that insert the rotor carefully to avoid oil coming out. If necessary, add oil until to the upper edge of the rotor. Do not fill it up fully, you will need 0,5mm space where the glue can hold. Then glue the lid with Super Glue and press it for a few minutes. If you cannnnot avoid, that oil is on the surfaces to glue, just glue it outswide, works also perfectly. At last push the cogwheel on the rotor. Glue is not necessary, because the cogwheel fits perfect.
Recommendations:
I recommend to fix the large cogwheel from Marc Ayton's mechanic with a screw, because of the increased force the wheel may turn on its axis. (see picture).
Links to materials:
Oil: Ultimate RC Silikonöl 30.000 CPS minimum Viscosity, better more (Amazon)
O-Ring: 8mm x 1,5mm (Amazon)
