Prusa Core One and MMU3 Profile for Orca Slicer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Prusa Core One and MMU3 Profile for Orca Slicer
- Ocena
- 5 / 5
- Polubienia
- 38
- Pobrania
- 271
- Wydruki
- 1
- Wyświetlenia
- 1141
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Change Log at bottom of description. I will update it occasionally for new profiles or changes that I make
Instructions to import the profile
Add the "Prusa Core One" using Orca Slicers “Select/Remove printers(system presets)”
Import the config by selecting file > import > import configs
Adjust the filament settings if needed.
Video guide by @Victor
If there are any problems with the profile or improvements you made and want to share send me a PM or comment on the post.
I did not make this profile all by myself, I used @Victor profile for the MK4S as a base line and changed all the relevant settings to fit the Core One.
I tested the profile on my own printer and verified that it works, I'm new to Orca so there might be settings I missed or don't know yet so your milage may vary.
Good luck and Happy printing :)
Change Log:
18/3/2026:
1) Added filament profiles for "Creality Hyper PLA", "ALMA PLA+" (Local) and a "Generic" which
should work with most PLA filaments.
2) Added "Process" (Print) profiles for the 0.4 Nozzle (non HF). (I'm working on a 0.6 Nozzle)
Profiles for 0.10, 0.15, 0.20 and 0.25 Layer heights (0.20 and 0.25 profiles are all tested, 0.10 and 0.15 are configured the same but not yet tested).
3) Ramming setting were a little tricky and I finally found a configuration that worked for my
filaments. I suggest that you'll do a little test print to see that all the settings are working for you
and adjust accordingly.
4) I tested to see which multiplier works best for automatic flushing volumes that Orca gives you,
from my tests with my filaments I found that a 0.5 multiplier works best in my case (a good
starting point to test from). I suggest using this MODEL to make the color flushing tests.
5) A heads up about the slicer, I don't know why but the estimated flush amounts seems to be around double from what really gets printed (gathered from over 15 test prints).
The model estimates seems to be fine so I'm not sure where the problem is, if anyone knows what the cause of it I would appreciate if you could send me a massage so I could fix it in the profile.