Parametric Shaft Coupler
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I remixed my Parametric Rigid coupler from http://www.thingiverse.com/thing:964671 to create this. It is essentially…
- Ocena
- 5 / 5
- Polubienia
- 17
- Pobrania
- 271
- Wydruki
- 4
- Wyświetlenia
- 1223
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
I remixed my Parametric Rigid coupler from http://www.thingiverse.com/thing:964671 to create this. It is essentially the same as that, but I took out a couple of variables that were specific to its use.
There are probably a few other couplers out there, but having it parametric makes it very easy to make just the right coupler you need.
I used 2 - M3x14mm bolts & locknuts for the 5mm to 5mm that is shown printed in Yellow PETG.
You can also open this in the Customizer
Instructions
The 5mm to 5mm shaft took 1:05:12 to print on my machine & weighed2.06oz. with an infill of 50%.
If you are testing a different size, I would print it half height to start with so you can test both the horizontal bolts & shafts. There are 15 variables you can change & they should be well commented to what they do.
Category: 3D Printer Parts