Waveshare OV5648 5MP USB Camera Mount Arm for Voron Switchwire
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a camera mount arm for the Voron Switchwire which allows use of PanzerObserver's OV5648 mount.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 175
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
I created this to utilise PanzerObserver's OV5648 Camera Mount in my Voron Switchwire prior to attaching the panel enclosures. It allows the camera to be positioned high up at the front as if attached to the top panel. The model uses a 40cm M10 Flexible Goosneck Hose and consists of a base and arm. My original arm was 50cm wider as my Switchwire is non-standard. I remodelled and shortened it at the request of a community member.
The Arm attaches to the Base (using the Flexi arm) on the left side 3060 extrusion using M5 bolts and T-Nuts.
You will need to download and print PanzerObserver's OV5648 Camera Mount (3 models) from his GitHub HERE.
Print in PLA/PETG for no enclosure, or ABS/ASA with enclosure.
Layer Height: 0.2mm
Extrusion Width: 0.4mm
Infill: 30%
Type: Grid, Cubic, Honeycomb, Triangle or Gyroid,
Walls: 4
Top/Bottom Layers: 5
Hardware Required:
40cm M10 Flexible Goosneck Hose - I sourced my one from eBay (HERE). NOTE, it has a hollow threaded M10 bolt to connect the base of the Goosneck, which inserts from the bottom of the arm base. Others have a thread at both ends for a nut. This may fit but I haven't tried it.
2 of M3x20 SH bolts. These are used to add strength to the top of the flexi arm attachment.
2 M3x10 or M3x12 SH or BH bolts. These are used to attach PanzerObservr's mount to the arm.
4 x M3 heat set inserts. Two are used for the M3x20 bolts, 2 for the PanzerObserver mount.
2 x M5x8 BH or SH bolts to mount the Base to the frame of the printer.
2 x M5 T Nuts (roll in type).
Assembly is fairly self-explanatory. The Arm is printed with the front face DOWN Insert the heat inserts into the holes for the camera mount and at the face of the Arm for the M3x20 bolts.
Insert the Flexi arm upper through the hole in the Arm and connect the top nut. I didn't use a nut on my one as it was a tight fit.
Insert the M10 hollow nut from the bottom of the Base and scrw the Flexi ar into it.
Screw the camera mount to the face of the Arm. Use zip ties for the cable. I have modelled in places to insert zip ties in both the Base and the Arm.
This model is a bit quick and dirty but it worked for me. I hope it is of use for you.