PolyDryer vertical stand (Snapmaker U1 chamber heater)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Vertical stand for PolyDryer / SnapDryer to be used as Snapmaker U1 chamber heater
- Ocena
- 4 / 5
- Polubienia
- 12
- Pobrania
- 36
- Wydruki
- 1
- Wyświetlenia
- 993
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This stand allows PolyDryer units to be positioned vertically inside a printer enclosure for heating printer chambers. The upright orientation keeps the LCD visible, provides bottom cutouts for cable access and power switch operation, and includes routing paths for cleaner cable management.
⚠ Important Notes
Ensure adequate clearance inside your printer so that no moving parts can contact the dryer or you may risk damaging your printer.
PolyDryer units include thermal protection and will enter fault mode if internal temperatures exceed approximately 75 °C. When this occurs, the unit shuts down and must be manually reset. It is recommended to monitor your settings to stay under this thermal limit especially for long prints.
Rubber or foam adhesive feet are strongly recommended for stability and grip.
✨ Features
Just slot in to (either screen-side up or on/off-switch side up).
Available in single or double stand versions
Re‑purpose PolyDryers as chamber heaters
Functions as a display stand
Integrated cable routing cutouts
Printing
Supports are not required
Bottom front-lip is optional and can be excluded from print (just de-select the part in the Object tab)
Disclaimer: Polymaker does not officially support or recommend using PolyDryer units inside printer enclosures. This design is experimental and provided as‑is.